Configuring The Interface Behavior; Configuring A Rip Version - HP 830 Series Configuration Manual

Step
3. Enable RIP on the interface
attached to the specified
network.

Configuring the interface behavior

Step
1. Enter system view.
2. Enter RIP view.
Disable the specified interface
3.
from sending routing updates
(the interfaces can still receive
updates).
4. Return to system view.
5. Enter interface view.
6. Enable the interface to receive
RIP messages.
7. Enable the interface to send
RIP messages.

Configuring a RIP version

A RIPv1-enabled interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts and unicasts.
A RIPv2-enabled multicast interface sends RIPv2 multicasts and can receive RIPv2 unicasts, broadcasts,
and multicasts.
A RIPv2-enabled broadcast interface sends RIPv2 broadcasts and can receive RIPv1 unicasts and
broadcasts, and RIPv2 broadcasts, multicasts, and unicasts.
You can configure a global RIP version in RIP view or an interface-specific RIP version in interface view.
If an interface has an interface-specific RIP version, the version takes precedence over the global one. If
no interface-specific version is specified, the interface uses the global RIP version. If neither global nor
interface-specific RIP version is configured, the interface sends RIPv1 broadcasts, and can receives RIPv1
broadcasts and RIPv1 unicasts, and RIPv2 broadcasts, multicasts, and unicasts.
To configure a RIP version:
Step
1. Enter system view.
2. Enter RIP view.
Command
network network-address
Command
system-view
rip [ process-id ]
silent-interface { interface-type
interface-number | all }
quit
interface interface-type
interface-number
rip input
rip output
Command
system-view
rip [ process-id ]
134
Remarks
By default, RIP is disabled on
interfaces.
Remarks
N/A
N/A
Optional.
All interfaces can send routing
updates by default.
N/A
N/A
Optional.
Enabled by default.
Optional.
Enabled by default.
Remarks
N/A
N/A