Displaying And Maintaining Ipv6 Is-Is; Ipv6 Is-Is Configuration Examples; Ipv6 Is-Is Basic Configuration Example - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Step
1. Enter system view.
2. Enable an IS-IS process and
enter IS-IS view.
3. Configure the NET for the IS-IS
process.
4. Enable IPv6 for the IS-IS
process.
5. Return to system view.
6. Enter interface view.
7. Enable IPv6 for an IS-IS
process.
8. Enable BFD for IPv6 IS-IS.

Displaying and maintaining IPv6 IS-IS

Execute display commands in any view. For other display and reset commands, see
Task
Display information about routes
redistributed by IPv6 IS-IS.
Display IPv6 IS-IS routing information.
Display IPv6 IS-IS topology information.

IPv6 IS-IS configuration examples

IPv6 IS-IS basic configuration example

Network requirements
As shown in
same AS. Configure IPv6 IS-IS on the switches so that they can reach each other.
Switch A and Switch B are Level- 1 switches, Switch D is a Level-2 switch, and Switch C is a Level- 1 -2 switch.
Figure 97, Switch A, Switch B, Switch C, and Switch D, all enabled with IPv6, reside in the
Command
system-view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
network-entity net
ipv6 enable
quit
interface interface-type
interface-number
isis ipv6 enable [ process-id ]
isis ipv6 bfd enable
Command
display isis redistribute ipv6 [ ipv6-address mask-length ]
[ level-1 | level-2 ] [ process-id ]
display isis route ipv6 [ ipv6-address ] [ [ level-1 | level-2 ] |
verbose ] * [ process-id ]
display isis spf-tree ipv6 [ [ level-1 | level-2 ] | verbose ] *
[ process-id ]
399
Remarks
N/A
N/A
By default, no NET is configured.
By default, IPv6 for the IS-IS
process is disabled.
N/A
N/A
By default, IPv6 is disabled for an
IS-IS process.
By default, BFD for IPv6 IS-IS is
disabled.
"Configuring IS-IS."