Configuring Is-Is Route Redistribution - HP MSR Series Configuration Manual
Layer 3 - ip routing
Hide thumbs
Also See for MSR Series:
- Configuration manual (889 pages) ,
- Command reference manual (684 pages) ,
- Wan access configuration manual (293 pages)
Table of Contents
Advertisement
Id
001
Configuring IS-IS route redistribution
Network requirements
As shown in
to interconnect. Router A and Router B are Level- 1 routers, Router D is a Level-2 router, and Router C is a
Level- 1 -2 router.
Redistribute RIP routes into IS-IS on Router D.
Figure 44 Network diagram
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Configure IS-IS basic functions:
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] is-level level-1
[RouterA-isis-1] network-entity 10.0000.0000.0001.00
[RouterA-isis-1] quit
[RouterA] interface serial 2/0
[RouterA-Serial2/0] isis enable 1
[RouterA-Serial2/0] quit
# Configure Router B.
<RouterB> system-view
[RouterB] isis 1
[RouterB-isis-1] is-level level-1
[RouterB-isis-1] network-entity 10.0000.0000.0002.00
[RouterB-isis-1] quit
[RouterB] interface serial 2/0
[RouterB-Serial2/0] isis enable 1
[RouterB-Serial2/0] quit
IPV4.State
Up
Figure
44, Router A, Router B, Router C, and Router D reside in the same AS. They use IS-IS
IPV6.State
MTU
Down
1497
155
Type
DIS
L1/L2
No/No
Advertisement
Table of Contents
Troubleshooting
