Ip Igmp Snooping Filter Add-Id - TP-Link JetStream TL-SL5428E Cli Reference Manual

a leave message from a host and the switch removing the host from the
multicast groups. Leave Time ranges from 1 to 30 in seconds. By default, it is 1.
port —— Static Router Port, which is mainly used in the network with stable
topology. There are two types of port: Fast Ethernet port, ranging from 1 to 24, in
the format of 1/0/2; Gigabit Ethernet port, ranging from 25 to 28, in the format of
1/0/25.
Command Mode
Global Configuration Mode
Example
Enable Multicast VLAN 3, and configure Router Port Time as 100 seconds:
TL-SL5428E(config)#ip igmp snooping multi-vlan-config 3 rtime 100

ip igmp snooping filter add-id

Description
The ip igmp snooping filter add-id command is used to configure the
multicast IP-range desired to filter. To delete the corresponding IP-range, please
use no ip igmp snooping filter add-id command. When IGMP Snooping is
enabled, you can specified the multicast IP-range the ports can join so as to
restrict users ordering multicast programs via configuring multicast filter rules.
Multicast IP addresses ranges from 224.0.0.0 to 239.255.255.255. The range
for receivers to join is from 224.0.1.0 to 239.255.255.255.
Syntax
ip igmp snooping filter addr-id addr-id list
no ip igmp snooping filter addr-id addr-id list
Parameter
addr-id list —— The filtering address ID to be bound.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Bind the filtering address ID 2-6 to Fast Ethernet port 3:
TL-SL5428E(config)#interface fastEthernet 1/0/3
TL-SL5428E(config-if)#ip igmp snooping filter addr-id 2-6
TL-SL5428E JetStream L2 Managed Switch CLI Guide
194