Tracert; Show System-Time - TP-Link TL-SG3210 Cli Reference Manual

tracert

Description
The tracert command is used to test the connectivity of the gateways during its
journey from the source to destination of the test data.
Syntax
tracert [ ip | ipv6 ] ip_addr [ maxHops ]
Parameter
ip —— The type of the IP address for tracert test should be IPv4.
ipv6 —— The type of the IP address for tracert test should be IPv6.
ip_addr —— The IP address of the destination device. If the parameter ip/ipv6 is
not selected, both IPv4 and IPv6 addresses are supported, for example
192.168.0.100 or fe80::1234.
maxHops —— The maximum number of the route hops the test data can pass
though. It ranges from 1 to 30. By default, this value is 4.
Command Mode
User EXEC Mode and Privileged EXEC Mode
Example
Test the connectivity between the switch and the network device with the IP
192.168.0.131. If the destination device has not been found after 20 maxHops,
the connection between the switch and the destination device is failed to
establish:
TL-SG3424# tracert 192.168.0.131 20
Test the connectivity between the switch and the network device with the IP
fe80::1234. If the destination device has not been found after 20 maxHops, the
connection between the switch and the destination device is failed to establish:
TL-SG3424# tracert fe80::1234 20

show system-time

Description
The show system-time command is used to display the current time system
and its source.
127