Offset/Gain Setting Operation (Function Version C Or Later) - Mitsubishi Electric Q62DAN User Manual

5 UTILITY PACKAGE (GX Configurator-DA)

5.6.2 Offset/gain setting operation (Function version C or later)

5 - 23
Perform the offset/gain setting operation in the following sequence.
(1) Switch to the offset/gain setting dialog box
Perform the operation in Section 5.6.1 to display the offset/gain setting dialog
box.
At this point, a dialog box to confirm the transition of module's operation mode
(normal mode -> offset/gain setting mode) is displayed. Click the Yes button to
transit to the offset/gain setting mode.
(2) Specify a channel
Specify the target channel of offset setting or gain setting on the channel No.
combo box.
(3) Specify offset/gain setting
Specify either offset setting or gain setting on the channel specified on the
channel No. combo box using the radio button.
(4) Set up adjustment values
Set up an adjustment value of the offset value or gain value. Select "1", "10,"
"100", or "1000" on the combo box, however, you can also set up adjustment
values by entering a number (1 to 3000).
MELSEC-Q
5 - 23