Grandstream Networks UCM6202 User Manual page 44
Ucm6200 series
ip pbx
Hide thumbs
Also See for UCM6202:
- User manual (308 pages) ,
- Quick installation manual (22 pages) ,
- Security manual (32 pages)
Table of Contents
Advertisement
IPv4 Address
Preferred DNS
Enter the preferred DNS server address. If Preferred DNS is used, UCM will try to use it
Server
as Primary DNS server.
WAN (when "Method" is set to "Route")
IP Method
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Address
Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Subnet Mask
Enter the subnet mask address for static IP settings. The default setting is 255.255.0.0.
Gateway IP
Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
DNS Server 1
Enter the DNS server 1 address for static IP settings. The default setting is 0.0.0.0.
DNS Server 2
Enter the DNS server 2 address for static IP settings.
User Name
Enter the user name to connect via PPPoE.
Password
Enter the password to connect via PPPoE.
Layer 2 QoS
802.1Q/VLAN
Assign the VLAN tag of the layer 2 QoS packets for WAN port. The default value is 0.
Tag
Layer 2 QoS
802.1p Priority
Assign the priority value of the layer 2 QoS packets for WAN port. The default value is 0.
Value
LAN (when Method is set to "Route")
IP Address
Enter the IP address assigned to LAN port. The default setting is 192.168.2.1.
Subnet Mask
Enter the subnet mask. The default setting is 255.255.255.0.
DHCP Server
Enable or disable DHCP server capability. The default setting is "Yes".
Enable
DNS Server 1
Enter DNS server address 1. The default setting is 8.8.8.8.
DNS Server 2
Enter DNS server address 2. The default setting is 208.67.222.222.
Allow IP
Enter the DHCP IP Pool starting address. The default setting is 192.168.2.100.
Address From
Allow IP
Enter the DHCP IP Pool ending address. The default setting is 192.168.2.254.
Address To
Default IP
Enter the IP lease time (in seconds). The default setting is 43200.
Lease Time
LAN (when Method is set to "Switch")
IP Method
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Address
Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Subnet Mask
Enter the subnet mask address for static IP settings. The default setting is 255.255.0.0.
Gateway IP
Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
DNS Server 1
Enter the DNS server 1 address for static IP settings. The default setting is 0.0.0.0.
UCM6200 Series User Manual
P a g e
|
43
Advertisement
Table of Contents
Troubleshooting
