Firmware Version 1.0.13.14
•
Added extension whitelist/blacklist for IVR dialing. [IVR]
•
Added ability to include DOD in PPI Header for SIP trunk. [Use DOD in PPI]
•
Added advanced IPv6 support including IPv6-to-IPv4 SIP calls, IPv6 router, IPv6 iptables/Static defense.
•
Added ability to customize PAI Header. [PAI Header]
•
Added blacklist for outbound calls. [Outbound Blacklist]
•
Added support to upload/download MOH package from Web GUI. [MUSIC ON HOLD]
•
Added support to download custom prompts from Web GUI. [Download All Custom Prompt]
•
Added option to configure prompt timeout in Dial By Name. [DIAL BY NAME]
•
Added description field in ZeroConfig settings to configure Softkey/Line/MPK for GXP series phones.
[PROVISIONING]
•
Improved seamless transfer privilege control. [Seamless transfer privilege control]
•
Added RTP Keep-alive support. [RTP Keep-alive]
•
Added Email Send Log. [Email Send Log]
•
Added support for Mitel simulation/protocol interfaces for PMS module. [PMS]
•
Added support for up to 10 failover trunks. [Use Failover Trunk]
Firmware Version 1.0.12.19
•
Added support for binding a mobile phone number to extension. [Mobile Phone Number]
•
Added support OPUS codec.
•
Added support call-barging privilege settings based on extensions. [Monitor privilege control]
•
Added support for Seamless Transfer. [Seamless Transfer]
•
Added support for Custom Call-Info for Auto Answer. [Custom Call-info for Auto Answer]
•
Added support for DND Whitelist. [Do Not Disturb]
•
Add the Field Description on Softkey, Line keys and MPK from Zero Config.
•
Added support to select interval for numbers on Batch add extension. [Extension Interval]
•
Added support for Batch Add CallerID Number. [CallerID Number]
•
Added support for Search Extensions Using CallerID Name.
•
Added support to Enable/Disable Inbound and Outbound Route. [Disable This Route/Disable This Route]
•
Added support for Outbound Route Time Condition. [Time Condition]
•
Added support for IPv6. [IPv6 Address]
•
Added Support for MTU configurable. [MTU]
•
Added support of CRM. [CRM]
•
Added support for Custom Privilege in User Management. [Custom Privilege]
•
Added Hotline support for FXS Extension. [Hotline]
•
Added support for Separate Wakeup Service. [WAKEUP SERVICE]
•
Added ability to provision phones from different network subnets using zero config. [Subnet Whitelist]
•
One-key-dial is replaced by Speed Dial to support more than one digit. [SPEED DIAL]
•
Added Append extension number in the end of DOD. [Direct Outward Dialing (DOD)]
UCM6200 Series User Manual
P a g e
|
23