Grandstream Networks UCM6202 User Manual page 100

File Prefix
File Postfix
Allow DHCP Option
43/66
Automatic Upgrade
Firmware Upgrade Rule
Web Access
Admin Password
End-User Password
Web Access Mode
Web Server Port
Security
Disable Telnet/SSH
Syslog
Syslog Server
Syslog Level
Send SIP Log
When URL is selected as firmware source, configure the firmware file prefix. If
configured, only the firmware with the matching encrypted prefix will be
downloaded and flashed into the phone, if URL is selected as firmware source.
When URL is selected as firmware source, configure the firmware file postfix.
If configured, only the configuration file with the matching encrypted postfix will
be downloaded and flashed into the phone.
If DHCP option 43 or 66 is enabled on the LAN side, the TFTP server can be
redirected.
If enabled, the endpoint device will automatically upgrade if a new firmware is
detected. Users can select automatic upgrading by day, by week or by minute.
•
By week
Once selected, specify the day of the week to check HTTP/TFTP server
for firmware upgrades or configuration files changes.
•
By day
Once selected, specify the hour of the day to check the HTTP/TFTP server
for firmware upgrades or configuration files changes.
•
By minute
Once selected, specify the interval X that the SIP end device will request
for new firmware every X minutes.
Specify how firmware upgrading and provisioning request to be sent.
Configure the administrator password for admin level login.
Configure the end-user password for the end user level login.
Select HTTP or HTTPS as the web access protocol.
Configure the port for web access. The valid range is 1 to 65535.
Enable Telnet/SSH access for the SIP end device. If the SIP end device
supports Telnet access, this option controls the Telnet access of the device; if
the SIP end device supports SSH access, this option controls the SSH access
of the device.
Configure the URL/IP address for the syslog server.
Select the level of logging for syslog.
Configure whether the SIP log will be included in the syslog message.
UCM6200 Series User Manual
P a g e | 99