Grandstream Networks UCM6202 User Manual page 168

•
Configure the name of the caller to be displayed when the extension has no
CallerID Name
CallerID Name configured.
Enable automatic recording for the calls using this trunk (for SIP trunk only). The
Auto Record default setting is disabled. The recording files can be accessed under Web
GUICDRRecording Files.
Advanced Settings
Select audio and video codec for the VoIP trunk. The available codecs are: PCMU,
Codec Preference PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723, iLBC, ADPCM,
H.264, H.263, H.263p and VP8.
Configure where to get the destination ID of an incoming SIP call, from SIP
DID Mode
Request-line or To-header. The default is set to "Request-line".
Configure the default DTMF mode when sending DTMF on this trunk.
DTMF Mode
Enable Heartbeat If enabled, the UCM6200 will regularly send SIP OPTIONS to the device to check
Detection if the device is still online. The default setting is "No".
When "Enable Heartbeat Detection" option is set to "Yes", configure the interval
Heartbeat Frequency (in seconds) of the SIP OPTIONS message sent to the device to check if the device
is still online. The default setting is 60 seconds.
Maximum Number of The maximum number of concurrent calls using the trunk. The default settings 0,
Call Lines which means no limit.
Select Fax mode. The default setting is "None".
•
•
Fax Mode
If the above two are missing, the "Global Outbound CID" defined in Web
GUIPBX SettingsGeneral Settings will be used.
•
Default: The global setting of DTMF mode will be used. The global setting
for DTMF Mode setting is under Web GUIPBX SettingsSIP
SettingsToS.
•
RFC2833: Send DTMF using RFC2833.
•
Info: Send DTMF using SIP INFO message.
•
Inband: Send DTMF using inband audio. This requires 64 bit codec, i.e.,
PCMU and PCMA.
•
Auto: Send DTMF using RFC2833 if offered. Otherwise, inband will be
used.
None: Disable Fax.
Fax Detect: Fax signal from the user/trunk during the call can be detected and
the received Fax will be sent to the Email address configured for this
extension. If no Email address can be found for the user, the Fax will be sent
to the default Email address configured in Fax setting page under Web
GUICall FeaturesFax/T.38.
UCM6200 Series User Manual
P a g e | 167