Table 51: Sip Register Trunk Configuration Parameters - Grandstream Networks UCM6202 User Manual

If checked, the trunk will be disabled.
Disable This Trunk Note: If a current SIP trunk is disabled, UCM will send UNREGISTER message
(REGISTER message with expires=0) to the SIP provider.
If the trunk has an assigned PSTN telephone number, this field should be set to
"User=Phone". Then a "User=Phone" parameter will be attached to the Request-
TEL URI Line and TO header in the SIP request to indicate the E.164 number. If set to
"Enable", "Tel:" will be used instead of "SIP:" in the SIP request. The default setting
is disabled.
Configure the Caller ID. This is the number that the trunk will try to use when
making outbound calls. For some providers, it might not be possible to set the
CallerID with this option and this option will be ignored.
When making outgoing calls, the following rules are used to determine which
CallerID will be used if they exist:
Caller ID
•
•
•
Select whether the trunk needs to register on the external server or not when
Need Registration
"Register SIP Trunk" type is selected. The default setting is No.
Enter the username to register to the trunk from the provider when "Register SIP
Username
Trunk" type is selected.
Enter the password to register to the trunk from the provider when "Register SIP
Password
Trunk" is selected.
Auth ID Enter the Authentication ID for "Register SIP Trunk" type.
Enable automatic recording for the calls using this trunk (for SIP trunk only). The
Auto Record default setting is disabled. The recording files can be accessed under Web
GUICDRRecording Files.
Basic Settings
Configure a unique label to identify this trunk when listed in outbound rules,
Provider Name
inbound rules etc.
Host Name Configure the IP address or URL for the VoIP provider's server of the trunk.
Configure the SIP transport protocol to be used in this trunk. The default setting is
"All - UDP Primary".
•
Transport
•
•
The CallerID configured for the extension will be looked up first.
If no CallerID is configured for the extension, the CallerID configured for the
trunk will be used.
If the above two are missing, the "Global Outbound CID" defined in Web
GUIPBX SettingsGeneral Settings will be used.

Table 51: SIP Register Trunk Configuration Parameters

UDP Only
TCP Only
TLS Only
UCM6200 Series User Manual
P a g e | 162