Table of Contents
Advertisement
4.2 RECORDING
To start a recording:
Check that there is an unlocked SD card (see § 2.9) in the PEL with sufficient
■
memory space.
Press the Select
■
is able to make recordings.
NOTE: If the device displays INSERT SD CARD, there is no SD card
in the device. If it displays SD CARD WRITE PROTECT, the SD card is
locked. If either message is displayed, recordings cannot be made.
Use the
■
times before turning solid.
Use the
■
Recordings can be managed from the PEL Control Panel as well (see § 5).
While recording, the device configuration cannot be modified. To enable or
disable Wi-Fi, press the Select
button to choose WIFI AP
4.3 MEASURED VALUE DISPLAY MODES
The PEL has 3 measurement display modes, Measurement Mode
Energy Mode
top of the display. To switch from one mode to another, use the or keys.
The displays can be accessed as soon as the PEL is turned on but the values will
be zero. The values will update when voltage or current is present at the inputs.
34
button first. The device will display START if the device
button to start the recording. The
button to stop the recording.The
, WIFI ST
, and Maximum Mode
Power & Energy Logger Model PEL 52 - User Manual
button twice and then press the Enter
, or no Wi-Fi, WIFI OFF.
, represented by the icons at the
symbol will blink a few
symbol will disappear.
,
Advertisement
Table of Contents
