Maintenance; Warning; Cleaning; Battery Replacement - AEMC 607 User Manual

Clamp-on meter

Hide thumbs Also See for 607:

Table of Contents

■ Remove the test leads on any input before opening the case.

■ Do not operate the clamp-on meter without a battery case cover.

■ To avoid electrical shock, do not attempt to perform any servicing unless you

are qualified to do so.

■ To avoid electrical shock and/or damage to the instrument, do not get water or

other foreign agents into the probe.

■ Disconnect everything connected to the device and set the switch to OFF.

■ Use a soft cloth moistened with soapy water. Rinse with a damp cloth and dry

quickly using a dry cloth or forced air.

■ Dry completely before putting back into use.

The

symbol indicates that the batteries are low. When this symbol appears

on the display unit, the batteries must be replaced. The measurements and

specifications are no longer guaranteed.

To replace the batteries, proceed as follows:

1. Disconnect the measurement leads from the input terminals.

2. Set the switch to OFF.

3. Using a screwdriver, unscrew the battery compartment cover from the

back of the housing (see § 3.1).

4. Remove the used batteries and replace them with (4) 1.5 V AA

batteries, observing the polarities.

5. Close the battery compartment cover and screw it onto the housing.

Clamp-On Meter Model 607- User Manual

6. MAINTENANCE

Table of Contents