Table of Contents
Advertisement
5.1
WARNING
Remove the test leads on any input before opening the case.
•
•
Do not operate the clamp-on meter without a battery case cover.
To avoid electrical shock, do not attempt to perform any servicing
•
unless you are qualified to do so.
To avoid electrical shock and/or damage to the instrument, do not get
•
water or other foreign agents into the probe.
5.2
CLEANING
Disconnect everything connected to the device and set the switch to
•
OFF.
Use a soft cloth moistened with soapy water. Rinse with a damp cloth
•
and dry quickly using a dry cloth or forced air.
•
Dry completely before putting back into use.
5.3
REPLACEMENT OF THE BATTERIES
The
symbol indicates that the batteries are low. When this symbol appears
on the display unit, the batteries must be replaced. The measurements and
specifications are no longer guaranteed.
To replace the batteries, proceed as follows:
1.
Disconnect the measurement leads from the input terminals.
2.
Set the switch to OFF.
3.
Using a screwdriver, unscrew the battery compartment cover from the
back of the housing (see §3.1).
4.
Remove the used battery and replace with a 9V LF22 battery, observing
the polarities.
5.
Close the battery compartment cover and screw it onto the housing.
5 MAINTENANCE
49
Advertisement
Table of Contents
