Overview – Web Server Interface - Honeywell touchpoint Pro Operating Instructions Manual

MAN0923_Issue 3_04/15
7.3 Overview – Web Server Interface
The Web Server displays live information from the Touchpoint Pro system. With the appropriate access level
permissions, events can be acknowledged and reset and event history can be analysed. Please refer to
Chapter 5 – User interface, Access Levels for details.
7.3.1 Start the Web Server
To use the Web Server, the Touchpoint Pro system must be connected to a network, please refer to
Chapter 6 - Commissioning, Setup Web Server for details.
To access the Touchpoint Pro system from a remote PC connected to the same network, open a web
browser and navigate to http://<IP Address> (where IP address is the address of the Touchpoint Pro system
on the network).
7.3.2 System Status Screen
The System Status screen provides a summary of the status of the Touchpoint Pro system as follows:
• Green tick – system OK, all input and output channels are in a Normal state
• Red bell – one or more input channels is in Alarm
• Yellow triangle - one or more channels is in Fault
• Orange triangle - one or more channels is in Inhibit
• Grey triangle - one or more channels is in Warning
7. Normal Operation
96
Touchpoint Pro
Operating Instructions