Honeywell touchpoint Pro Operating Instructions Manual page 233

MAN0923_Issue 3_04/15
20. Appendix 7 - Logged events and
where they are displayed
Event
Fault Acknowledged
Fault Cleared
Field Device Detached
Field Device detected
Field Input Test Mode
Acknowledged
Field Inputs Test ended
Field Inputs Test started
First Span Calibration
Gas Over Range
Gas Over Range Cleared
Gas Under Range
Gas Under Range Cleared
Hardware Fault
Hardware Fault acknowledged
Hardware Fault cleared
Hold Time Active
I/O Module Removed
Inhibit
Inhibit by CCB
Inhibit Cleared
Inhibit Cleared by CCB
Input Activation Acknowledged
Input Active
Input Cleared
Input Force Cleared
Comment
Logs the first span calibration for a
channel
Calculated gas concentration is
greater than the configured 'Gas
Over Range Limit'
Calculated gas concentration is
less than the configured 'Gas Under
Range Limit'
Hardware fault has occurred within
the Control Module
Configured delay for ROM channel
de-activation.
Channel has been inhibited by the
CCB because it is being configured,
or one of the channels on the same
module is being configured
Logged when DIM input active is
acknowledged
DIM channel active
Logged when DIM input active is
cleared
Displayed
Input Output
Details Details
screen screen
✔
✔
✔
✔
233
Touchpoint Pro
Operating Instructions
Specific
Active Inputs /
Channel Type
Events Outputs
(if applicable)
screen screen
All
mA, mV
✔
mV
mA, mV
mA, mV
mA, mV
mA, mV
ROM
All
✔ ✔ All
All
DIM
✔ ✔ DIM
DIM