Honeywell touchpoint Pro Operating Instructions Manual page 232

MAN0923_Issue 3_04/15
20. Appendix 7 - Logged events and
where they are displayed
Event
C&E Test Mode Acknowledged
COB FW Update
Configuration Backup created
Configuration has changed; save
backup
Configuration changed is
acknowledged
Configuration changed is cleared Logged after configuration backup
Configuration Data Deleted
Configuration Error
Configuration Error Cleared
Configuration Restored
Configuration Settings Test
ended
Configuration Settings Test
started
Configuration Test Mode
Acknowledged
Delay Time Active
Delay Time Inactive
Diagnostic Error
Diagnostic Error Cleared
DIM Channel Modified
DIM Configuration State Inhibit
DIM Configuration State Inhibit
Cleared
DIM User Inhibit
DIM User Inhibit Cleared
Fault
Comment
Logged when COB firmware is
updated
Logged after configuration backup
file is saved successfully
Configuration has been modified by
the user and after that Configuration
backup has not yet been carried out
Logged when user acknowledges
this event from menu on local or
remote user interface
file is saved successfully
Configuration has been restored
from a previously saved backup
Configured delay for ROM channel
activation.
Raised when channel runtime
diagnostics of IO module fails.
Channel is in Inhibit because the
module is being configured
Channel has been inhibited by the
user
Displayed
Input Output
Details Details
screen screen
✔
✔
✔
232
Touchpoint Pro
Operating Instructions
Specific
Active Inputs /
Channel Type
Events Outputs
(if applicable)
screen screen
✔
All
✔
ROM
ROM
All
All
DIM
DIM
DIM
DIM
DIM
✔ ✔ All