Honeywell touchpoint Pro Operating Instructions Manual page 236

MAN0923_Issue 3_04/15
20. Appendix 7 - Logged events and
where they are displayed
Event
PSU Channel Modified
PSU Decommissioned
Pwd for Accept button Disabled
by UI
Pwd for Accept button Enabled
by UI
Pwd for Reset button Disabled
by UI
Pwd for Reset button Enabled
by UI
Rate Alarm
Rate Alarm Acknowledged
Rate Alarm Cleared
Redundant CCB active, Master
failed
Redundant CCB Failure
Redundant CCB successfully
replaced
Relay Output Error
Relay Output Error Cleared
Remote Input Active
Remote Input Cleared
Reset Button Password Setting
Modified
Ring {0} Fault
Ring {0} Fault Acknowledged
Ring {0} Fault Acknowledged at
Ring {0} Fault at CCB
Ring {0} Fault at CCB
Acknowledged
Ring {0} Fault at CCB Cleared
Ring {0} Fault between Controller 0 will be replaced by A or B
Comment
One of the Status input channels
has been modified
One of the Status input channels
has been removed
Password settings changed
Password settings changed
Password settings changed
Password settings changed
Master CCB has failed and the
redundant CCB has taken over
control of the system
TBC
TBC
If DIM channel is active and, DIM is
participating in Remote Interactions.
The Reset button on the Touchpoint
Pro front panel can optionally be
password protected – the setting
has been changed
0 will be replaced by A or B.
0 will be replaced by A or B
0 will be replaced by A or B
0 will be replaced by A or B.
0 will be replaced by A or B
0 will be replaced by A or B
Displayed
Input Output
Details Details
screen screen
✔
✔
236
Touchpoint Pro
Operating Instructions
Specific
Active Inputs /
Channel Type
Events Outputs
(if applicable)
screen screen
✔ ✔ mA, mV
mA, mV
mA, mV
✔
ROM
ROM
✔ DIM
DIM
✔
✔