Available Modules - Honeywell touchpoint Pro Operating Instructions Manual

MAN0923_Issue 3_04/15
2. Overview / Introduction

2.6.1 Available Modules

Analogue Input Module 4–20 mA (AIM mA)
Analogue Input Module mV Bridge (AIM mV)
Digital Input Module (DIM)
Relay Output Module (ROM)
Note: Communication/Power Rails may be included in the system without any I/O Modules, however there is
a limit of 5 such Communication/Power Rails within the full 3 km loop of the system.
2.7 System Interaction
The User Interface consists of:
• Interface software with three ways to access:
Touchscreen for normal system operation, maintenance and configuration
Web Server for remote access to view normal system operation
PC Configuration Software (optional) for convenient system configuration
• Accept and reset buttons on the front panel of the Touchpoint Pro Controller
• Power, Alarm, Fault and Inhibit LEDs on the front panel of the Touchpoint Pro Controller
• Buzzer on the Touchpoint Pro Controller
Further System Interfaces consist of:
• Two master relays, System Failure and System Fault
• Connections for SD Card and USB memory device
• 10/100 Mbps Ethernet connection
• Optional digital bus interface
4-channel Analogue Input Module for 2 or 3 wire 4-20mA detector
signals
4-channel Analogue Input Module for mV-Bridge signals; powers up to 4
catalytic flammable gas detectors
4-channel Digital Input Module for switched input devices such as
manually operated push buttons. Can also be used for remote alarm
acknowledge, reset and output inhibit
4-channel Relay Output Module incorporating 4 SPCO relays; suitable to
activate field mounted annunciators
23
Touchpoint Pro
Operating Instructions