Backup / Restore Configuration - Honeywell touchpoint Pro Operating Instructions Manual

MAN0923_Issue 3_04/15

8.7 Backup / Restore configuration

Note: Engineer access level is required to back up the configuration. Administrator access level is required
to restore configuration.
Note: The Touchpoint Pro system remains available during this procedure.
It is recommended to back up the Touchpoint Pro system configuration once it is completed, and following
any changes to the setup or software.
Note: The SD Card fitted in the Touchpoint Pro Controller is used for logging event history. When the SD
Card is removed, data is logged in internal memory. To avoid potential loss of event history data, please
minimise the length of time that the SD Card is removed from the system.
Note: When the command "Eject SD Card" is used, the event history data is flushed from the internal
memory to the SD Card. To ensure that event history is maintained on one SD Card and minimise loss of
event history data during updates, please eject the SD Card from the Touchpoint Pro, copy any required
files and replace it in the system as soon as possible. If a different SD Card is
used, some event history data may be saved to the second card, and will no longer be accessible from the
Touchpoint Pro.
To back up the configuration:
1. Ensure that the SD Card memory device is inserted in the Control Module
2. If not already logged in, login with a valid engineer level user name
3. From the System Status screen select the Extras icon then System Configuration
4. Re-enter the password and press Login
5. Select CCB Management and click on Configuration Backup
6. Select the required drive
7. The system will display a message "The configuration backup process might take a few minutes.
The User Interface is not accessible during this time. Do you want to proceed?" Please ensure that
source drive is always connected during the operation.
8. Once the action is confirmed, the configuration backup process starts and a progress message is
displayed. The backup may take several minutes depending on the system size
9. The Configuration backup file is stored on the memory device in:
\SD Card Drive\TPPR Configuration\TPPR_Config_SystemID.bin
To restore the configuration:
1. Make sure that the backup SD Card is inserted in the Control Module SD Card socket with the
configuration backup file saved in:
\Hard Disk\\TPPR Configuration\TPPR_Config_SystemID.bin
2. If not already logged in, login with a valid administrator level user name
3. From the System Status screen select the Extras icon then System Configuration
4. Re-enter the password and press Login
8. Maintenance
122
Touchpoint Pro
Operating Instructions