Honeywell touchpoint Pro Operating Instructions Manual page 235

MAN0923_Issue 3_04/15
20. Appendix 7 - Logged events and
where they are displayed
Event
mV Configuration State Inhibit
mV Configuration State Inhibit
cleared
mV Fault Recovery Inhibit
mV Fault Recovery Inhibit
cleared
mV module inhibited channel
mV module Inhibited channel
Cleared
mV User Inhibit
mV User Inhibit Cleared
New I/O Channel added
New I/O Module detected
Open Circuit
Open Circuit Cleared
Output Active
Output Active Forced
Output Deactive Forced
Output Forced
Output Verification Error
Output Active Force Cleared
Output Cleared
Output Deactive Force Cleared
Output Force Cleared
Output Verification Error Cleared
PC Config SW Login
PC Config SW Logout
Peak Hold
Peak Hold Active
Comment
Channel is in Inhibit because the
module is being configured
Channel is in inhibit because a
fault recovery delay time has been
configured
TBC
Channel has been inhibited by the
user
TBC
ROM channel output active
ROM channel output has been
forced to activate
ROM channel output has been
forced to deactivate
ROM channel output has been
forced to activate
TBC
Logged when user logs in from PC
Logged when user logs out from PC
When actual gas concentration
value rises above the configured
maximum gas range
TBC
Displayed
Input Output
Details Details
screen screen
✔
✔
235
Touchpoint Pro
Operating Instructions
Specific
Active Inputs /
Channel Type
Events Outputs
(if applicable)
screen screen
mV
mV
mV
mV
mV
mV
mV
mV
All
✔
mV
mV
✔ ROM
ROM
✔ ROM
ROM
ROM
ROM
ROM
✔ ✔ mA, mV