Hazardous Area Enclosure - Honeywell touchpoint Pro Operating Instructions Manual

MAN0923_Issue 3_04/15
3. Mechanical Installation

3.3 Hazardous Area Enclosure

Caution: The Touchpoint Pro enclosure is heavy (refer to table of typical weights, single person lift is
not recommended). Before lifting the enclosure, consider and implement control measures to reduce
the risk of injury. Refer to local safety regulations.
The Touchpoint Pro range includes a wall mounted enclosure which is certified for use in hazardous areas/
locations (ATEX/IECEx Zone 2, Class I Div 2, and Class I (Zone 2)). This enclosure can only be used as a
remote unit, no controller option is available.
Fixing bolts should be of minimum diameter 8 mm, to a depth of minimum 50 mm.
Caution: It is the installer's responsibility to select the appropriate fixings taking into account the
structure of the mounting surface and the weight of the enclosure.
The typical weight of the hazardous area enclosure is shown in the table below. Please be aware that the
weight may vary depending on the options selected.
510
560
590
Figure 3.5 Touchpoint Pro Hazardous Area Enclosure
Description
Hazardous Area Enclosure
Ø11
Approximate Weight in kg
42
31
Touchpoint Pro
Operating Instructions
325