Honeywell touchpoint Pro Operating Instructions Manual page 82

MAN0923_Issue 3_04/15
14. The system will return the new value, press Accept to confirm
15. Press Exit and close the menu window
16. Repeat steps 7 – 15 for each configured channel
17. Proceed to section 6.8
6.8 Commission Input / Output Modules
Note: Administrator level access is required
1. If not already logged in, login with a valid administrator level user name
2. From the System Status screen select the Extras icon then System Configuration
3. Re-enter the password and press Login
4. Select System Setup
5. If this is a first time configuration, the system will indicate that the Ring network must be initialised.
Press the Ring Network icon
6. The screen will display the System Setup tree list of all Input / Output modules , PSU Status Inputs and
Control Centre Board(s) installed on the system. The modules are displayed in the order left to right on
the communication / power rail (looking at the rail), and in the direction of Ring A round the complete
system (if remote units are being used)
7. Select the required module, press the Menu icon
8. Select a module ID number between 1 and 48 (the default is the next available number) and press Send
to send it to the system
9. The system will then return the value, which will be displayed on the screen. Confirm that it is correct
and press Accept for the setting to take effect
10. Repeat for all un-commissioned modules on the system
6. Commissioning
Figure 6.4 System Setup Data
to initialise the network manually
82
and select Commission Module
Touchpoint Pro
Operating Instructions