Honeywell touchpoint Pro Operating Instructions Manual page 234

MAN0923_Issue 3_04/15
20. Appendix 7 - Logged events and
where they are displayed
Event
UI SW Update
Local HMI Functional
Local HMI Login
Local HMI Logout
Local HMI OFF
Local HMI ON
LTEL Alarm
LTEL Alarm Acknowledged
LTEL Alarm Cleared
mA Configuration State Inhibit
mA Configuration State Inhibit
cleared
mA Fault Recovery Inhibit
mA Fault Recovery Inhibit
cleared
mA module inhibited channel
mA User Inhibit
mA User Inhibit cleared
Modbus Update
Module Configuration Modified
Module Fault Acknowledged for
Module Fault Cleared for
Module Fault for
Module ID assigned
Module Inhibit Cleared
Module Removed
Module Replaced
mV Auto Inhibit
mV Auto Inhibit cleared
Comment
Logged when local HMI is updated
Logged when Local HMI System
Status screen is shown (this
indicates Local HMI is functional)
Logged when user logs in from HMI
Logged when user logs out from
HMI
TBC
TBC
Channel is in Inhibit because the
module is being configured
Channel is in inhibit because a
fault recovery delay time has been
configured
Channel has been inhibited by the
user
Logged when modbus application is
updated
mV channel has been configured
but not yet calibrated
Displayed
Input Output
Details Details
screen screen
✔
234
Touchpoint Pro
Operating Instructions
Specific
Active Inputs /
Channel Type
Events Outputs
(if applicable)
screen screen
✔ ✔ mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
All
All
All
mV
mV