Honeywell touchpoint Pro Operating Instructions Manual page 237

MAN0923_Issue 3_04/15
20. Appendix 7 - Logged events and
where they are displayed
Event
Ring {0} Fault Cleared at
Ring Communication Error
Ring Communication Error
Cleared
Ring Oscillation Fault
Ring Oscillation Fault
Acknowledged
Ring Oscillation Fault Cleared
ROM Channel Modified
ROM User Inhibit
ROM User Inhibit Cleared
SD Card Full - Overwriting old
data
SD Card inserted
SD Card memory 80% full
SD Card missing
SD card system ID mismatch
Sensor Catalogue
Sensor Lifetime Exceeded
Sensor Lifetime Exceeded
Cleared
Session kill by UI
Session kill by PC
Short Circuit
Short Circuit Cleared
Signal Over Range
Comment
0 will be replaced by A or B
If Module is in Fault all channels
of the Module will show Ring
Communication Error
TBC
Channel has been inhibited by the
user
The inserted SD card contains data
from a different Touchpoint Pro
system
Logged when sensor catalogue is
updated
Sensitivity of the mV sensor has
dropped below 50% of the original
value
A user on the touchscreen has
ended another user's login session
A user on the PC Configuration
Software has ended another user's
login session
TBC
Sensor mA or mV signal reading is
greater than the configured 'Signal
Over Range Limit'
Displayed
Input Output
Details Details
screen screen
✔ ✔
✔
✔
✔
237
Touchpoint Pro
Operating Instructions
Specific
Active Inputs /
Channel Type
Events Outputs
(if applicable)
screen screen
All
All
ROM
✔
✔
✔
mV
mV
mA, mV
mA, mV
mA, mV