Honeywell touchpoint Pro Operating Instructions Manual page 231

MAN0923_Issue 3_04/15
20. Appendix 7 - Logged events and
where they are displayed
Event
Alarm 3 Acknowledged
Alarm 3 Cleared
Alarm acknowledged
Alarm cleared
Auxiliary output overload
Auxiliary output overload
acknowledged
Auxiliary output overload cleared
Bead Current Fault
Bead Current Fault Cleared
Buzzer Activation Settings
Modified
Calibration Active
Calibration Inactive
Calibration Overdue
Calibration Overdue Cleared
Cause and Effect Test ended
Cause and Effect Test started
CCB Configuration Modified
CCB FW Update
CCB Master Configuration
transferred
CCB Redundancy Mode changed CCB redundancy mode can be
CCB Redundant Configuration
transferred
CCB-COB Communication lost
Channel Decommissioned
Comment
Occurs when a short circuit is
detected on one of the ROM
auxiliary voltage output channels
When bead current for channel
deviates +/-1% from configured
value.
The buzzer can be configured to
determine by which event types it
is activated – the setting has been
changed
The configured 'Calibration
Reminder Interval' has been
exceeded
Logged when CCB firmware is
updated
CCB configuration has been
transferred from the master to the
redundant CCB
either single or dual CCB
CCB configuration has been
transferred from the redundant to
the master CCB
Error in the system, or fault with
CCBs
Displayed
Input Output
Details Details
screen screen
✔
✔
231
Touchpoint Pro
Operating Instructions
Specific
Active Inputs /
Channel Type
Events Outputs
(if applicable)
screen screen
mA, mV
mA, mV
✔ ROM
ROM
ROM
mV
mV
mA, mV
mA, mV
✔
All