Using RP Flash Memory Cards
Using RP Flash Memory Cards
Installing and Removing a Flash Memory Card
Note
Step 2
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
4-44
This section describes how to use RP flash memory cards and includes
information on the following topics:
•
•
•
•
•
•
The PCMCIA flash card slots are designated as slot 0 (left) and slot 1 (right). Both
flash memory card slots can be used at the same time.
If there are dual GRPs, the slots in the primary GRP are designated slot 0 and
slot 1. The slots in the secondary GRP are designated sec-slot 0 and sec-slot 1.
The following procedures can be used for a flash memory card in either slot
position.
Refer to
Figure 4-5
and the following procedure to install a flash memory card.
Remove the flash memory slot cover by loosening its captive screw (illustration
is shown without the cover for clarity).
Hold the flash memory card with the connector end of the card toward the slot and
the label facing right (see
Chapter 4
System Startup and Basic System Configuration
Figure
4-5a).
OL-11496-01