Cisco 12410 Installation And Configuration Manual page 189

Chapter 4 System Startup and Basic System Configuration
Cisco IOS User Interface
line vty 0 4
password bambam
no snmp server
!
no ip routing
!
interface Ethernet0
no shutdown
ip address 172.16.72.2 255.255.255.0
!
interface POS1/0
shutdown
no ip address
!
interface SDCC1/0
shutdown
no ip address
.
.
.
interface POS15/0
shutdown
no ip address
!
interface SDCC15/0
shutdown
no ip address
!
end
[0] Go to the IOS command prompt without saving this script.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
Building configuration ...
Use the enabled mode 'configure' command to modify this configuration.
Milo#
You can set configuration parameters using the setup command facility, or you can
enter the setup command at any time at the privileged EXEC prompt to activate
the setup facility. When you enter setup using the setup command, the script
displays any existing (previously entered) system configuration settings within
square brackets [ ].
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
4-21
OL-11496-01