Removing and Replacing AC and DC Power Subsystem Components
Set the power switch to the on (1) position.
Step 12
The (green) Pwr OK indicator on the front of the power supply should light. If the
indicator does not light, see the
Installation" section on page
Removing and Replacing a DC PEM
This section contains the procedure to remove and replace an DC power entry
module (PEM) from the chassis.
Cisco 12010, Cisco 12410, and Cisco 12810 series routers are available with
either an original or enhanced capacity DC power supply:
Figure 7-22 DC PEM Components—2400 Watt
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
7-40
Figure
7-22—2400 W DC power supply components
•
Figure
7-23—2800 W DC power supply components
•
PW R OK
FAU LT
2
3
TE MP
PWR OK
FAULT
TEMP
1
ON
OFF
1
Power switch
2
Status indicators
Chapter 7
"Troubleshooting the AC Power Supply
7-34.
4
3
Handles
4
Ejector lever
Maintaining the Router
OL-11496-01