Troubleshooting The Blower Module Installation - Cisco 12410 Installation And Configuration Manual

Removing and Replacing the Blower Module

Troubleshooting the Blower Module Installation

Step 1
Step 2
Step 3
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
7-26
Use the following procedure to troubleshoot the blower module if it is not
operating properly after installation.
Be sure the router is powered on and that all power cords are connected properly.
Loosen the captive screws and reseat the blower module to the chassis.
Retighten the captive screws to ensure the blower module is properly seated
•
to the backplane connector.
Check the blower module status indicators:
OK (green)—Indicates that the blower module is operating normally. This
•
indicator should light as soon as the blower module is installed and receives
power from the backplane connector.
If this indicator remains on, and the blower module fans fail to operate
–
after several attempts to reseat the blower module, replace it with a spare.
If the spare blower module also fails, power off the router and contact a
–
Cisco service representative for assistance.
Fail (red)—This indicator remains off during normal operation. If this
•
indicator is on, the system has detected a fan failure or other fault in the
blower module.
If this indicator remains on, and the blower module fans fail to operate
–
after several attempts to reseat the blower module, replace it with a spare.
If the spare blower module also fails, power off the router and contact a
–
Cisco service representative for assistance.
Chapter 7 Maintaining the Router
OL-11496-01