Cisco 12410 Installation And Configuration Manual page 210

Recovering a Lost Password
enable "use net in IP bcast address"? y/n [n]:
enable "load rom after netbootfails"? y/n [n]:
enable "use all zero broadcast"? y/n [n]:
enable "break/abort has effect?" y/n [n]:
enable "ignore system config info?" [n]: y
change console baud rate? y/n [n]:
change boot characteristics? y/n [n]
Configuration Summary
enabled are:
console baud: 9600
boot: image specified by the boot system command
or default to: cisco2-prp
do you wish to change the configuration? y/n [n]
You must reset or power cycle for the new config to take effect
rommon 1>
Enter the initialize command to initialize the router.
Step 4
rommon 1> initialize
After the router completes its power cycle, the software configuration register is
set to ignore the configuration file. The router boots the system image and
displays the system configuration dialog:
.
.
.
Enter no in response to the system configuration dialog prompts until the
Step 5
following instruction is displayed:
Press RETURN to get started!
Press Return.
Step 6
After some interface configuration information is displayed, the user EXEC mode
prompt appears:
Milo>
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
4-42
Chapter 4
--- System Configuration Dialog ---
System Startup and Basic System Configuration
OL-11496-01