Cisco 12410 Installation And Configuration Manual page 102

PRP Port Connection Guidelines
Figure 2-21
•
•
Figure 2-21 Using the Ethernet Port on the PRP
(Cisco 12000
series router)
(Cisco 7500
series router)
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
2-38
shows:
You cannot access Network 2.0.0.0 from Ethernet port (E0) on the GRP in
Router A. You can only access Host A, Host B, and Router C, which are in
Network 1.0.0.0 (see dotted-line arrows).
To access Network 2.0.0.0 from Router A, you must use an interface port on
one of the line cards (a POS line card in this example) in Router A. Data from
Router A is routed through Router B and Router C, to reach Network 2.0.0.0
(see solid-line arrows).
Router A
EO
POS
EO
Router B
Network 1.0.0.0
Host A
Host B
Router C
(Cisco 7500
series router)
Chapter 2 Preparing for Installation
Network 2.0.0.0
Host A
OL-11496-01