Cisco 12410 Installation And Configuration Manual page 121

Chapter 3 Installing the Router
Handle all cards by the metal card carrier edges only; avoid touching the board or
Caution
any connector pins. After removing a card, carefully place it in an antistatic bag
or similar environment to protect it from ESD and dust in the optic ports
(fiber-optic line cards).
Use the following procedure to remove line cards and RPs from of the chassis.
Step 1 Proceeding from left to right, identify each card and write down the card type and
slot number on a piece of paper
Note
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
You will need this information when you reinstall the cards in the chassis
to be sure you install them in the same card slots.
Removing Cards from the Chassis
(Figure 3-8).
3-13