Attaching Bezel Extenders To The Front Cover - Cisco 12410 Installation And Configuration Manual

Removing and Installing the Front Covers and Bezel Extenders on Original Cisco 12010 Series Routers

Attaching Bezel Extenders to the Front Cover

Step 1
Step 2
Step 3
Caution
Step 4
Caution
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
7-6
Use the following procedure to attach the bezel extenders to the card cage front
cover.
Remove the line card and RP card cage front cover from the chassis as described
in the "Removing the Front Covers" section on page
Remove the four ball studs from the front cover
Screw the four ball studs into the threaded holes on the bezel extenders (two ball
studs for each bezel extender) using a wrench to secure them.
Do not overtighten the ball studs. Overtightening the ball studs could damage the
threaded hole on the bezel extender.
Attach the bezel extenders to the front cover:
Facing the inside of the front cover, align the screw holes in the left side bezel
a.
extender with the mounting screw holes in the front cover
item 4).
If you cannot align both screw holes on the front cover inserts, you have
Note
the incorrect bezel extender. Try the other bezel extender on this side.
Fasten the bezel extender to the front cover with the mounting screws
b.
(Figure 7-2, item 2).
Do not overtighten the screws. Overtightening the screws could damage the
threaded holes in the front cover.
Repeat Steps a and b to fasten the right side bezel extender to the other side
c.
of the front cover (Figure 7-2, item 5).
Chapter 7 Maintaining the Router
7-3.
(Figure 7-2, item 3).
(Figure
OL-11496-01
7-2,