Cisco 12410 Installation And Configuration Manual page 81

Chapter 2 Preparing for Installation
Site Requirement Guidelines
You must terminate DC power cables using cable lugs at the power shelf
end.Ensure the lugs are dual-hole and that they fit over M6 terminal studs at
0.625-inch (15.88-mm) centers (for example, Panduit Part Number LCD8-14A-L
or equivalent).
Figure 2-9 shows the type of lug required for DC-input cable connections.
Figure 2-9 DC Power Cable Lug
All measurements in inches
2.24
End View
Ø 0.267
0.48
2 holes
Crimp area
0.25 0.63 0.37
0.08
Figure 2-10 shows a typical source DC power distribution scheme for a 2400 W
DC PDU.
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
2-17
OL-11496-01