Connecting Alarm Display Card Cables - Cisco 12410 Installation And Configuration Manual

Connecting Alarm Display Card Cables

Connecting Alarm Display Card Cables

Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
3-50
The Ethernet interfaces on the PRP are endstation devices only, not
Note
repeaters.
The router alarm display card, which is located above the horizontal cable
management tray, has two 25-pin D-subconnectors, labeled Alarm A and Alarm B
(Figure 3-32).
Figure 3-32 Alarm Display Card Cable Connection
Alarm display
A
ALARM A B
ALARM B
MBUS CSC
SFC
FAIL
ENABLE
A B 0 1
0 1 2 3 4
Chapter 3 Installing the Router
OL-11496-01