Cisco 12410 Installation And Configuration Manual page 276

Using the diag Command
Table 6-1
source-path
halt
previous
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
6-10
diag Command Reference (continued)
Specifies the path to the diagnostic image file
c12k-fdiagsbflc-mz.IOS Release
Where IOS Release corresponds to the Cisco IOS release
number. For example:
c12k-fdiagsbflc-mz.120-25.S
In this example 120-25.S corresponds to Cisco IOS
Release 12.0(25)S.
The following are examples of the source path for flash
cards:
slot0:c12k-fdiagsbflc-mz.120-25.S
•
slot1:c12k-fdiagsbflc-mz.120-25.S.
•
The following is an example of the source path for a TFTP
server:
tftp://tftp_server_ip_address/my_directory/c12k-fdiags
•
bflc-mz.120-25.S.
(Optional) Stops diagnostic testing on the line card.
If you stop the field diagnostic test using the diag halt
command, the line card remains down (in an unbooted
state). Generally, you stop testing to remove or replace the
line card. If this is not the case, and you need to bring the
line card back up (online), use the microcode reload slot
global configuration command, or power cycle the line
card by removing and replacing it in its slot.
(Optional) Displays previous test results (if any) for the
card.
Chapter 6 Router Field Diagnostics
OL-11496-01