Cisco 12410 Installation And Configuration Manual page 340

Removing and Replacing AC and DC Power Subsystem Components
Figure 7-31 Connecting the DC Power Cables—2800 W PDU
– 48/60V RTN
(+)
– 48/60V (–)
– 48/60V (–)
Feed A2
– 48/60V RTN
Step 13
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
7-58
+
– –
+
-48/-60V
-40A MAX (2x)
(+)
Replace the clear plastic safety covers over the PDUs and tighten the screws (see
Figure 7-29).
Be sure to use the correct safety cover after you have replaced a PDU.
Note
Safety covers for 2400 W PDUs are a 1-piece design as shown in
Figure 7-29; safety covers for 2800 W PDUs use an upper and lower,
2-piece design.
Chapter 7
+
– –
+
-48/-60V
-40A MAX (2x)
Maintaining the Router
Ground
OL-11496-01