Using Rp Flash Memory Cards; Installing And Removing A Flash Memory Card - Cisco 12416 Installation And Configuration Manual

Using RP Flash Memory Cards

Using RP Flash Memory Cards

Installing and Removing a Flash Memory Card

Note
Step 1
Step 2
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
4-44
This section describes how to use RP flash memory cards and includes
information on the following topics:
Installing and Removing a Flash Memory Card, page 4-44
•
Formatting a New Flash Memory Card, page 4-47
•
Specifying a Cisco IOS Software Image to Boot the System, page 4-48
•
Flash Memory Commands, page 4-49
•
• Booting from Flash Memory, page 4-52
Copying Image Files to or From Flash Memory, page 4-52
•
The PCMCIA flash card slots are designated as slot 0 (left) and slot 1 (right). Both
flash memory card slots can be used at the same time.
If there are dual GRPs, the slots in the primary GRP are designated slot 0 and
slot 1. The slots in the secondary GRP are designated sec-slot 0 and sec-slot 1.
The following procedures can be used for a flash memory card in either slot
position.
Refer to Figure 4-5 and the following procedure to install a flash memory card.
Remove the flash memory slot cover by loosening its captive screw (illustration
is shown without the cover for clarity).
Hold the flash memory card with the connector end of the card toward the slot and
the label facing right (see
Chapter 4 System Startup and Basic Configuration
Figure 4-5a).
OL-11495-01