Configuring The Software Configuration Register - Cisco 12410 Installation And Configuration Manual

Chapter 4 System Startup and Basic System Configuration

Configuring the Software Configuration Register

OL-11496-01
!
map-list atm1
ip 10.1.1.1 atm-vc 1
ip 10.1.1.3 atm-vc 2
ip 10.1.1.4 atm-vc 4
ip 10.0.0.1 atm-vc 3
ip 10.0.0.5 atm-vc 10
ip 10.0.0.6 atm-vc 11
no logging trap
!
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
password bambam
login
!
end
The software configuration register is a 16-bit register in NVRAM that defines
specific system parameters. You can set or change the contents of this register to
accomplish the following tasks:
Define the boot sources for the default Cisco IOS software, assigning them in
•
the following order of precedence:
Flash memory card inserted in PCMCIA slot 0
–
– TFTP server on the network
Flash memory SIMM (NVRAM) on the route processor
–
Boot image stored within the operating environment
–
• Define a default boot filename.
Enable or disable the Break function.
•
Control broadcast addresses.
•
Set the console terminal baud rate.
•
Recover a lost password.
•
Force an automatic boot using a boot image.
•
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide

Configuring the Software Configuration Register

4-31