Prp Ethernet Connections - Cisco 12410 Installation And Configuration Manual

Hide thumbs Also See for 12410:
Table of Contents

Advertisement

Chapter 2
Preparing for Installation
PRP Port Connection Guidelines

PRP Ethernet Connections

The PRP has two RJ-45 MDI Ethernet ports; ETH0 and ETH1
(Figure
2-20).
Figure 2-20 PRP Ethernet Connections
ETH 0
ETH 1
These connections support IEEE 802.3 and IEEE 802.3u interfaces compliant
with 10BASE-T and 100BASE-TX standards. The transmission speed of the
Ethernet ports is "autosensing" by default and is user configurable.
The PRP Ethernet port does not provide external routing functions. Its primary
roles are to act as a Telnet port into the router, and to boot or access Cisco IOS
software images over a network to which the PRP Ethernet port is directly
connected.
Cisco Express Forwarding (CEF) functions on these ports are switched off by
Caution
default for security reasons. We strongly caution you to consider the security
implications of switching on CEF routing functions on these ports.
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
2-37
OL-11496-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

1281012010

Table of Contents