Cisco 12410 Installation And Configuration Manual page 227

Chapter 4 System Startup and Basic System Configuration
Milo# copy startup-config slot0:myfile2
20575008 bytes available on device slot0, proceed? [confirm]
Address or name of remote host [1.1.1.1]?
Loading new.image from 1.1.1.1 (via Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 7799951/15599616 bytes]
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCC
Milo#
•
•
Enter the dir command to verify that the configuration file is copied correctly to
Step 3
the memory card in slot 0.
Milo# dir slot0:
-#- -length- -----date/time------ name
1
3
4
5
9197156 bytes available (11381148 bytes used)
Milo#
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
The exclamation points (!!!) appear as the file is being copied.
The C characters signify the calculation of the CRC, which verifies that the
file is copied correctly.
5200084 May 10 1997 19:24:12 gsr-p-mz.112-8
1215 May 10 1997 20:30:52 myfile1
6176844 May 10 1997 23:04:10 gsr-p-mz.112-8.1
1186 May 10 1997 16:56:50 myfile2
Using RP Flash Memory Cards
4-59