Prerequisites And Preparation; Powering Off The Router - Cisco 12410 Installation And Configuration Manual

Powering Off the Router

Prerequisites and Preparation

Powering Off the Router

Step 1
Step 2
Step 3
Step 4
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
7-2
Before you perform any of the procedures in this chapter, be sure that you:
Review the "Safety Guidelines" section on page
•
Read the safety and ESD-prevention guidelines described in the
•
and Safety Information" section on page
Ensure that you have all of the necessary tools and equipment before
•
beginning the procedure.
Have access to the following documents during the installation:
•
Regulatory Compliance and Safety Information for Cisco 12000 Series
–
Routers publication that shipped with the router (PN 78-4347-xx)
Most Cisco 12010, Cisco 12410, and Cisco 12810 series routers field-replaceable
units (FRUs) can be removed and replaced with the power on and the system
operating. This is known as online insertion and removal (OIR). Power supplies,
line cards, the RP, CSCs, SFCs, and alarm cards all support OIR. Unless otherwise
noted, the maintenance tasks described in this chapter can be performed while the
router remains powered on.
In some cases it may be necessary to power off the router, for example, to upgrade
both power supplies and PDUs. Use the following procedure to power off the
router.
Set the power switch on each power supply to the off (0) position.
Power off all circuit breakers for the source power lines connected to the power
supplies.
Verify that the Pwr OK indicator on each power supply is off.
Verify that the OK indicator on the blower module is off.
Chapter 7 Maintaining the Router
2-2.
"Compliance
2-3.
OL-11496-01