Cisco 12410 Installation And Configuration Manual page 204

Configuring the Software Configuration Register
Set the contents of the software configuration register by entering the
Step 3
config-register value command, where value is a hexadecimal number preceded
by 0x.
Milo(config)# config-register 0xvalue
Note
Press Ctrl-Z to exit global configuration mode.
Step 4
Milo(config)# config-register 0xvalue
Milo(config)# Ctrl-Z
Milo#
Enter the show version command to verify the software configuration register
Step 5
value that is currently in effect, and the new value you entered (in Step 3) the next
time the router reloads.
Milo# show version
.
.
.
Configuration register is 0x141 (will be 0x102 at next reload)
Enter the copy running-config startup-config command to save the software
Step 6
configuration register settings to NVRAM.
Milo# copy running-config startup-config
Reboot the system.
Step 7
Note
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
4-36
Consult the hexadecimal column in
possible settings to enter as the 4-bit value parameter.
Configuration register changes take effect only after the system reboots
(for example, when you enter a reload command from the console).
Chapter 4 System Startup and Basic System Configuration
Table 4-4 on page 4-32 for the
OL-11496-01