Using Flash Memory Cards In The Rp - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Performing Other Configuration Tasks
Step 11
Step 12
Step 13
Step 14
Step 15

Using Flash Memory Cards in the RP

This section presents procedures for using Flash memory cards in the Route Processor
(RP). The following topics are covered in this section:
•
Installing and Removing a Flash Memory Card in a RP
•
Formatting a Flash Memory Card
•
Specifying a Cisco IOS Image for Booting the System
•
Console Commands Associated with Flash Memory Use
•
Enabling Booting from Flash Memory
4-46
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
Enter the show start-up config command at the privileged EXEC mode prompt
to display the enable password in the configuration file:
show start-up config
Router#
.
.
.
Issue the configure terminal command at the privileged EXEC mode prompt to
enter the global configuration mode:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Change the software configuration register setting back to its original value (as
noted earlier from Step 3). Alternatively, change this value to 0x0102 (the
factory default) by issuing the config-register 0xvalue command:
config-register
Router(config)#
Router(config)#
Exit the global configuration mode by entering Ctrl-Z:
Ctrl-Z
Router(config)#
Router#
Reboot the router and enable it using the recovered password.
0xvalue