Reinstalling Dc Pems - Cisco 12410 Installation And Configuration Manual

Chapter 3 Installing the Router

Reinstalling DC PEMs

Step 1
Caution
Figure 3-22 Installing a DC PEM
Step 2
Step 3
OL-11496-01
Use the following procedure to reinstall the DC PEMs back into the chassis.
Install the DC PEM (Figure
Slowly push the power supply into the chassis until it mates with the
a.
backplane connector at the back of the bay.
To prevent damage to the power shelf backplane connector, do not use excessive
force when inserting a power supply into the chassis.
Lift the ejector lever into place and tighten the captive screw to securely seat
b.
the power supply to the backplane connector.
Repeat Step 1 for the other power supply.
Go to the "Reinstalling the Blower Module" section on page 3-32
blower module.
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
Reinstalling Components After Installing the Chassis
3-22):
to install the
3-31