Connecting Alarm Card Cables; Figure 3-23 Alarm Card Connectors - Cisco GSR12/60 - 12012 Router -AnyLAN, SONET/SDH Installation And Configuration Manual

Connecting Alarm Card Cables

Connecting Alarm Card Cables
The alarm card has two, 25-pin D-sub connectors, labeled ALARM 1 and ALARM 2,
mounted on the alarm card faceplate. (See Figure 3-23.)
Figure 3-23
The alarm card connectors enable you to connect the Cisco 12012 to a site alarm
maintenance system. Critical, major, and minor alarms generated in the Cisco 12012
system are displayed by LEDs on the alarm card faceplate. The generated alarms also
control alarm relays mounted on the alarm card. The alarm relay contacts are accessible
through the two alarm card connectors.
3-48 Cisco 12012 Gigabit Switch Router Installation and Configuration Guide
Alarm Card Connectors
Critical, major, and
minor alarm LEDs
Audio alarm
cutoff switch
Pin 1 Pin 1
ALARM 1 ALARM 2
Pin 25 Pin 25
Clock and scheduler card
and switch fabric card LEDs
ALARM