Rep 2.4 Drum Assembly - Xerox ColorQube 8570 Service Manual

14. Install the ribbon cable retaining clip.
Figure 26 Installing the Retaining Clip
15. Install the Ground Strap and 2 screws.
16. Install the Jetstack Cap.
17. Install the Funnel Cap.
18. Install the Ink Loader.
19. Perform the Homing the Printhead Forward to Print Position procedure
the Head Tilt Gear.
20. Reassemble the remaining components, and turn the printer power on.
21. Print the Light Stripes page. Check if any jets are being substituted. If necessary, use the
Control Panel to reset the jet substitution.
22. Package the defective Printhead and completed Printhead Checklist in the replacement
part's packaging.
Xerox Internal Use Only - Revised, 3rd Revision
ColorQube 8570/8870 Service Manual

REP 2.4 Drum Assembly

Parts List on
Removal
NOTE: For additional tips, refer to the
ColorQube 8570/8870 Training materials).
1. Remove the Control Panel Cover
2. Remove the Right Side Cover
3. Remove the Control Panel
4. Remove the Left Side Cover
5. Remove the Drum Maintenance Unit
6. Remove the Exit Cover
7. Remove the Ink Loader
8. If the Printhead is tilted forward, perform Printhead Parking procedure
the Printhead.
9. If the Wiper Assembly is in raised position, perform Wiper Blade Alignment procedure
(ADJ 1.1) to place the Printhead Wiper in its lowered, home position.
10. Remove the Media Drive Assembly
11. Remove the Y-Axis Belt
Spring Arm toward the front. With the tension released, slide the belt off the pulley.
12. Remove the Exit Module
13. Remove the Lower Inner Duplex Guide
14. Remove the Inner Simplex Guide and Pre-Deskew Sensor
15. Remove the Outer Duplex Guide
16. Remove the Upper Duplex Guide and Solenoid
17. Remove the Stripper Carriage Assembly and Transfix Roller
18. Remove the Transfix Arm Kit with Pins
(ADJ 1.2) to home
19. Remove the Drum Temperature Sensor
October 2012
4-29
PL 2.1 Item 4
Drum Assembly Removal
(REP 1.5).
(REP 1.11).
(REP 1.6).
(REP 1.10).
(REP 1.16).
(REP 1.7).
(REP 1.8).
(REP 4.5).
(REP 2.5). Relieve tension on the belt by pulling the end of the
(REP 3.13).
(REP 3.2).
(REP 3.4).
(REP
(REP 2.21).
(REP 6.5).
video (also available in the
(ADJ 1.4) to park
(REP 3.1).
3.5).
(REP 2.13).
Repairs and Adjustments
REP 2.3, REP 2.4