User Information File; Enabling The User Info Table; Gateway User Information For Pbx Extensions And "Global" Numbers - AudioCodes Mediant 1000 User Manual

# debug auxilary-files dial-plan match-number <Dial Plan
number> <prefix number>
For example, the following checks whether the called prefix number 2000 is defined in
Dial Plan 1, which is used for obtaining the destination IP address (tag):
# debug auxilary-files dial-plan match-number PLAN1 2000
Match found for 4 digits
Matched prefix: 2000
Tag: 10.33.45.92

43.1.8 User Information File

This section describes the User Info table.

43.1.8.1 Enabling the User Info Table

Before you can use the User Info table, you need to enable the User Info functionality, as
described in the following procedure.

To enable the User Info table:
1. Make sure that your device's License Key provides far-end users support ("FEU"). To
view the License Key, see ''Viewing the License Key'' on page 763.
2. Open the Proxy & Registration page (Setup menu > Signaling & Media tab > SIP
Definitions folder > Proxy & Registration).
3. From the 'Enable User-Information Usage' drop-down list (EnableUserInfoUsage),
select Enable:
Note: The 'Enable User-Information Usage' parameter appears in the Web interface
only if the device's License Key is defined with far-end users.
4. Reset the device with a save-to-flash for your settings to take effect; the User Info
table now appears in the Web interface.

43.1.8.2 Gateway User Information for PBX Extensions and "Global" Numbers

The GW User Info table contains user information that can be used for the following
Gateway-related features:

Mapping (Manipulating) PBX Extension Numbers with Global Phone Numbers:
maps PBX extension number, connected to the device, with any "global" phone
number (alphanumerical) for the IP side. In this context, the "global" phone number
serves as a routing identifier for calls in the "IP world" and the PBX extension uses this
mapping to emulate the behavior of an IP phone. This feature is especially useful in
scenarios where unique or non-consecutive number translation per PBX is needed.
This number manipulation feature supports the following call directions:
•
IP-to-Tel Calls: Maps the called "global" number (in the Request-URI user part) to
the PBX extension number. For example, if the device receives an IP call
destined for "global" number 638002, it changes this called number to the PBX
extension number 402, and then sends the call to the PBX extension on the Tel
side.
User's Manual
Figure 43-5: Enabling User Info Table
754
Mediant 1000B Gateway & E-SBC
Document #: LTRT-27045