Http-Based Proxy Services - AudioCodes Mediant 1000 User Manual

4. SBC Calls: In the IP-to-IP Routing table, configure the 'Destination Type' parameter of
the routing rule to Routing Server (see Configuring SBC IP-to-IP Routing Rules on
page 656), as shown below:
Figure 15-46: Configuring Routing Rule to use Routing Server
5. Gateway Calls: Enable routing based on Routing server, by configuring the
GWRoutingServer parameter to 1.
15.6

HTTP-based Proxy Services

The device supports the following HTTP-based proxy services:

HTTP Reverse Proxy for Managing Equipment behind NAT:
You can configure the device to function as a reverse HTTP proxy server. This
functionality is required to enable administrators to manage communication equipment
(such as IP Phones) over HTTP when the equipment is located behind NAT (e.g., in
the LAN) and the administrator is located in a public domain (e.g., in the WAN). Thus,
this functionality resolves NAT issues, enabling the administrator to access the IP
Phone's management interface (e.g., embedded Web server).
To support the functionality, the following configuration is required:
1. Enable the HTTP Proxy application (see ''Enabling the HTTP Proxy Application''
on page 273).
2. Define a local, listening HTTP interface for the leg interfacing with the
administrator (see ''Configuring HTTP Interfaces'' on page 273).
Note: It is recommended not to use port 80 as this is the default port used by IP
Phones for their Web-based management interface.
1. Define each HTTP-based managed equipment:
a.
b.
Note: For this feature, no special configuration is required on the managed
equipment.

HTTP-based EMS Services for AudioCodes Equipment behind NAT:
You can configure the device to act as an HTTP Proxy that enables AudioCodes EMS
to manage AudioCodes equipment (such as IP Phones) over HTTP when the
equipment is located behind NAT (e.g., in the LAN) and EMS is located in a public
domain (e.g., in the WAN). Thus, the feature resolves NAT traversal issues. The IP
User's Manual
Define the URL prefix for accessing the equipment's management interface
(see ''Configuring HTTP Proxy Services'' on page 275). To access the
equipment's management interface, the administrator needs to enter the
following URL in a Web browser:
http://<device's WAN IP address:port>/url prefix/
Define the IP address of the managed equipment (see ''Configuring HTTP
Proxy Hosts'' on page 276).
Mediant 1000B Gateway & E-SBC
272 Document #: LTRT-27045